Our units help control the power factor which allows efficient use of electricity through out the entire home, condo or apartment. The unit also provides whole house surge protection which protects valuable electronic devices like computers, plasma TV’s, refrigerators, water pumps, etc. Our 1200 units pays for itself fast and keeps saving you money year after year.

 

Beware of used or refurbished equipment as this type of equipment contains electrolytic capacitors which have a design life.

 

 

 

The Wattsdog Power Saver 1200 units were designed with the homeowner in mind, providing lower energy bills, increased motor and appliance life, as well as surge and lightning protection for all of the equipment inside of your house.

 

Everyone who has an electric bill should have a Power Saver! Residential customers throughout North America should see a savings of 10% minimum and as much as 35% on their electrical usage (and thus power bills).

- Power Savers have been in use in the commercial industry for decades increasing machinery motors life.

 

American and Canadian homes all have the same problem. They inefficiently handle inductive load. Inductive load is anything in the home that runs by motor including refrigerators, freezers, air conditioners, heat pumps, washers, dryers, fans, blower motors, pool pumps, dish washers, vacuum cleaners and hair dryers. You get the picture, right?

 

All motors require a certain amount of reactive power (non-working power) from the utility to create the Electro-Magnetic-Field (EMF) around the motor to make it work. The problem is that your local utility delivers that reactive power to your home without knowing how much you really need. Your inductive load (motors) then uses what it needs and sends the rest back to your electric panel where it is "lost" - dispersed in heat never to be seen again. This loss is called I2R loss or "line loss". The problem with this equation is that you have paid for the lost electricity, because it's traveled thru your meter and been measured.

 

The Power-Save 1200 unit stores the reactive power (non-working power) that would be otherwise lost. This allows your inductive motor load to push in and pull from the Power Save 1200 using the stored power, instead of asking for more from the utility. This process decreases your demand from the utility thereby decreasing your Kwh usage and lowering your bill each month!

The Power-Save 1200 is UL Listed and recognized by the Department of Energy; don't be fooled by imitators!

 

- Voltage 100 ~ 240 Volts AC 50/60 Hertz Single Phase

- Internal Protection 10,000 Amp Fault Currents

- Easily Connected To 100 Amp and 200 Amp Service Panels

 

 

 

- GE - USA made capicitors

- Whole House Surge Protection

- Lightning Protected

- No Moving Parts 20 Year Design Life

 

 

 

- 6" x 6" x 4" deep

- up to 240 volt AC,  single phase - 200 amp.

- Plastic or Metal incasing for indoor/outdoor use.

- Metal incasing for indoor/outdoor.

- all with mounting holes.

- Very light – only 4~6 lbs

 

 

- A small gray box - that saves you money!

- Fits neatly next to your breaker panel and or plug it to a 110 outlet nearby.

- Saves you hundreds, if not thousands, of dollars year after year and protects the entire home.

(Picture is of our 1200-P - 110 Plug in)

 

 

 

 

 

 

 

 

 

  - 1200 = Single phase - 200 amp

  - 3200 = Three phase - 200 amp

  - 3400 = Three phase - 400 amp

 

 

 

 

 

  - 1200-P - Plastic casing with 110 plug

  - 1200-M - Metal casing, 10 guage wire

  - 1200-C - Commercial grade unit

          - XL / Heavy duty capacitors

 

 

 

 

  - 3200M - 30 amp three pole breaker

  - 3400M - 40 amp three pole breaker

 

  - NEMA Metal casing

  - w/ 8 guage wire